Separate names with a comma.
M104 S195 T0
M109 S195 T0
G29 ; autolevel
G1 E-1.0000 F1800
G1 Z1.400 F1000
; process Process1
I’m at my wits end trying to figure this out. It’s random when it does it but does it on every print. Temp doesn’t change it.
Hatchbox filament PLA 192 degrees
Heated bed 55 degrees
I installed a E3Dv6 and started having this problem. Very rough layers for the...
Any way to fill these gaps? I’m using Simplify3D. This is the print preview. I’m trying to make some cookie cutters and I need them as...
This is what is have in my END GCODE. I need my Y axis to move out but it moves in after the print is done. I think i need to change the G28(home)...
Got another small problem. The gears are kind of "shaving" off. Leaving dust all over the place.
Sent from my iPhone using Tapatalk
While printing, the filament gear/motor is making a weird chirping noise when it stops or maybe retracts. I'm uploading a video. Pay attention to...
Hello guys. So I'm trying to print this disc.
Hotend 185 degrees
Heated bed 60 degrees.
About .30 inch thick
What would I use to attach magnets to the heat bed? I got a replacement bed and the magnets didn't come installed on the bed.
Thanks in advance!
Hatchbox ABS red filiment
Print time about 3 hours
I'm printing this box and it keeps warping on me....
I was having some trouble with the layer height in my new printer. It printed a few parts very nice. Then it started not extruding. So I thought.....
MC says the temp is at 220 degrees always and I set it at 210. It then has the arrow going down but never goes down to 210 and stays at 220, but...