Separate names with a comma.
There was a smallll piece and it solved the problem, it was really smallll, THX
The screen is clean, but also the delete and set buttons are blinking
No, I did not, and it dont go away also
Why do I get this screen in the middle of printing?
Can I bypass the heated bed? I need to print some stuff?
Not just one pin, but two pins. does it happen often?
One of the pins on the left seems to be lower then others
Unhandled communication error
The was an unhandled error while talking to the printer. Due to that OctoPrint disconnected. Error: Heating failed,...
Everything works fine, thanks again, problem solved
Thanks a lot. I uninstalled the sensor plugin and now it has been printing for 25 min without problem, let see how far it goes.
Everything is correct, but still got the message, when doing the wizard, it loads, starting to print it stops?
Why do I get this message after every 10 sec?
Thx, I'll try it tonight
Thank you, problem solved.
Those two parts get too close. There is no distance between. They start vibrate.
[ATTACH] Before to print, the extruder makes terrible noise at home position, how to change the position? Those two parts are too close to each...
To save time, can you give me advice how to set it.
Before the extruder starts to move, it makes terrible noise (in left corner)?
Metal backplate is connected to the plastic, how to...
robo 3d r2 when unboxed, the z-offset nozzle moves to the left corner?