1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. xfire_dragonx
    Thread

    Solved Lift nozzle after G29 start code

    Heyo, been a while since being here asking a question about my start code - did have my start code setup to have the nozzle lift after the G29 of...
    Thread by: xfire_dragonx, Jan 25, 2023, 5 replies, in forum: General Questions
  2. xfire_dragonx
    Thread

    Solved Start Gcode help

    I'm looking for the gcode that raises the hot end after the last g29 before printing and can't remember the dang code. G28 M565 G1 Z5 F5000...
    Thread by: xfire_dragonx, Jun 30, 2022, 1 replies, in forum: General Questions
  3. xfire_dragonx
    Thread

    Solved Z axis manual spin

    Just a question about the R1, when I rotate the left z axis by hand the right z axis rotates. Is there a belt that connects the 2 Z axis, if not...
    Thread by: xfire_dragonx, Jan 10, 2019, 1 replies, in forum: General Questions
  4. xfire_dragonx
    Thread

    Partial Answer print not original shape in z axis

    I'm stuck on trying to figure this out. why my print is being squashed, it seems the z axis spreading some how. [ATTACH]
    Thread by: xfire_dragonx, Nov 8, 2018, 86 replies, in forum: Troubleshooting
  5. xfire_dragonx
    Thread

    Solved Power supply fan not running

    New power supply installed and everything works. Does the power supply fan turn on automatically or does it have a heat sensor system? The fan...
    Thread by: xfire_dragonx, Sep 5, 2018, 3 replies, in forum: Troubleshooting
  6. xfire_dragonx
    Thread

    Solved Power supply fan not running

    Get everything back together on my printer, only to find the power supply fan not working. The power unit in my printer is the stock version. I...
    Thread by: xfire_dragonx, Aug 30, 2018, 3 replies, in forum: General Questions
  7. xfire_dragonx
    Thread

    Solved Extruder motor still not working

    My printer went down due to a extruder motor. I have replaced my board and have a new motor at this time. with the new motor is it a plug and...
    Thread by: xfire_dragonx, Aug 30, 2018, 5 replies, in forum: Troubleshooting
  8. xfire_dragonx
    Thread

    Solved Stock picture of robo ardruino wired

    I'm currently re wiring my arduino board, I didn't take a pic when i should have. Now i'm just looking for a stock pic of the wiring. Mainly to...
    Thread by: xfire_dragonx, Aug 27, 2018, 21 replies, in forum: General Questions
  9. xfire_dragonx
    Thread

    Solved 3d r1+ Filament motor issue

    Today i changed out my filament motor wiring to the adruino board. I had an issue with the wire connection to the motor, jimmy rigged it and...
    Thread by: xfire_dragonx, Aug 16, 2018, 25 replies, in forum: Troubleshooting
  10. xfire_dragonx
    Thread

    Solved Z axis drop during print R1+

    Hello and welcome to Z axis drop. My issue started after i replaced my thermistator, after everything was done back in it's place I noticed the...
    Thread by: xfire_dragonx, Jun 2, 2018, 24 replies, in forum: Troubleshooting
Showing results 1 to 10 of 10
Search Again