1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Non-warping, no smell, PET filament

Discussion in 'Printing Filament' started by Ruser, Aug 30, 2015.

  1. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,275
    When in doubt, measure the resistance.
     
  2. KTMDirtFace

    KTMDirtFace Well-Known Member

    Joined:
    May 18, 2015
    Messages:
    1,247
    Likes Received:
    461
    I have been printing a lot in ESUN PETG.. and its great. My only problem is after awhile i get some buildup on the nozzle..that eventually comes off leaving a booger somewhere in the print.

    Anyone know what the cause and fix for that is?

    I tried upping the retraction because this stuff oozes a bit but that didn't seem to help.
     
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,806
    Likes Received:
    3,521
    @KTMDirtFace sometimes a very small change in extrusion multiplier will help. I am talking about in the hundredths decimal place.

    S3D - Extruder >> Extrusion Multiplier
    Slic3r - Filament Settings >> Extrusion multiplier
    Print Studio - Settings >> Advanced Settings >> Extrusion >> Extrusion width multiplier
    MC - Advanced Controls >> Slice Settings >> Filament
     
  4. Kevin Allan

    Kevin Allan New Member

    Joined:
    May 1, 2017
    Messages:
    4
    Likes Received:
    0
    learning so many things in this forum
     

Share This Page