1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. DavidR
    Thread

    Support Settings for this piece

    I feel like this piece likely needs support. When enabling support in Cura, it shows the supports being built inside the structure as well. This...
    Thread by: DavidR, Jan 20, 2018, 3 replies, in forum: General Questions
  2. DavidR
    Thread

    lights dimmed

    The 2 main white lights (not the blue ones) have dimmed on my machine. I have no idea why this has happened. Does anyone have an idea of how to...
    Thread by: DavidR, Jan 19, 2018, 0 replies, in forum: Troubleshooting
  3. DavidR
    Thread

    Replacing Main Board

    I have received a new main board. I opened up the rectangle under where the print bed normally rests. This is insufficient as theres a screw...
    Thread by: DavidR, Jan 19, 2018, 3 replies, in forum: Troubleshooting
  4. DavidR
    Thread

    Hard Bounds on Cura slicer settings

    I am new to printing in general and am humbled by the enormous number of settings I can tweak. I was wondering what the extremes (i.e. the...
    Thread by: DavidR, Jan 17, 2018, 13 replies, in forum: General Questions
  5. DavidR
    Thread

    boiling looking print

    What is the culprit here? This happens relatively frequently where I will have this "boiling" appearance on my prints.
    Thread by: DavidR, Jan 16, 2018, 1 replies, in forum: Troubleshooting
  6. DavidR
    Thread

    belt tensioning

    My belts are broken in. I bought a spring loaded belt tensioner but I can't seem to find anywhere to put it where it wont cause problems. At best...
    Thread by: DavidR, Jan 14, 2018, 7 replies, in forum: Troubleshooting
  7. DavidR
    Thread

    Greasing 6mm rods

    The guide mentions that the included grease can be used in place of white lithium grease for greasing the Z-axis screw. It is mum as to whether...
    Thread by: DavidR, Jan 14, 2018, 1 replies, in forum: General Questions
  8. DavidR
    Thread

    Solved Issue with thin prints

    Imagine you are printing a vertical pencil. I am having the following issue with prints like this, about halfway up the printer starts to layer...
    Thread by: DavidR, Jan 8, 2018, 2 replies, in forum: Troubleshooting
  9. DavidR
    Thread

    Bed Calibration Wizard

    I am running this wizard in guided mode. It is telling me to use the Z-offset Tool to level the printer and I have no idea what this means. I...
    Thread by: DavidR, Jan 8, 2018, 10 replies, in forum: General Questions
  10. DavidR
    Thread

    overextrusion during pre-print sequence

    During the pre-print sequence (I'm not sure what this is actually called-- the sequence of movements where the bed and extruder go up and down and...
    Thread by: DavidR, Jan 6, 2018, 3 replies, in forum: Troubleshooting
  11. DavidR
    Thread

    firmware upgrade

    I have received an R2 for Christmas. I have updated the OS; I am curious as to whether or not I should have the current firmware release already...
    Thread by: DavidR, Jan 5, 2018, 4 replies, in forum: Software
Find older messages
Showing results 21 to 31 of 31
Search Again
Page 2 of 2