1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

About to buy an R1

Discussion in 'General Questions' started by Nathanfish, Aug 6, 2015.

Page 9 of 9
  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    The belt is not the only thing to consider. Pulleys and drive cogs matter too. Make sure they are not slipping.
     
    #161 mark tomlinson, Sep 16, 2015
  2. Nathanfish

    Nathanfish Active Member

    Joined:
    Aug 6, 2015
    Messages:
    306
    Likes Received:
    34
    I pulled the bed off and everything seems tight. Now i'm wondering if it's always printed like this and i just haven't noticed. I reflashed the firmware and printed with both matter control and simplify3d with the same results. The Robo tech only had the idea that something was loose but i don't see anything different between printers.
     
    #162 Nathanfish, Sep 17, 2015
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    "Everything seems tight" meaning you tried to tighten down the set screw or just wiggled things around. Being crystal clear is important so we know exactly what you did
     
    #163 Mike Kelly, Sep 17, 2015
Page 9 of 9

Share This Page